Page 1 of 1

Vossenjacht pieper V1.1

Posted: Thu Oct 15, 2020 11:07 am
by pe1br




DB9 pin 1 microphone gnd
DB9 pin 2 Microphone
DB9 pin 3 PTT
DB9 pin 5 en 9 GND
DB9 pin 6 + 8 volt

door button S4 lang ingedrukt te houden kom je in een 2de menu, de rode led blijft nu branden.
Hier kun je de cal instellen voor de CW callgever:
  • button S1 spatie
    button S2 dot
    Button S3 dash
    Button S4 (lang vasthouden) terug naar normaal bedrijf
Eenmaal geprogrammeerd wordt de call in de EEprom van de Arduino opgeslagen en blijft er in staan.

Re: Vossenjacht pieper V1.1

Posted: Thu Oct 15, 2020 11:09 am
by pe1br
Yaesu



Pin 3 >> DB9 pin 6
Pin 4 >> DB9 pin 9
Pin 5 >> DB9 pin 2
Pin 6 >> DB9 pin 3

Re: Vossenjacht pieper V1.1

Posted: Fri Oct 16, 2020 9:06 pm
by pe1br
Kenwood rond:



pin 1 >> DB9 pin 2
pin 2 >> DB9 pin 3
pin 5 >> DB9 pin 6
pin 7 >> DB9 pin 1
pin 8 >> DB9 pin 9

Re: Vossenjacht pieper V1.1

Posted: Fri Oct 16, 2020 9:15 pm
by pe1br
Kenwood RJ45:



pin 2 >> DB9 pin 6
pin 3 >> DB9 pin 9
pin 4 >> DB9 pin 3
pin 5 >> DB9 pin 5
pin 6 >> DB9 pin 2

Re: Vossenjacht pieper V1.1

Posted: Fri Oct 16, 2020 9:18 pm
by pe1br
Icom RJ45:

Image
PIN1 >> DB9 pin 6
PIN4 >> DB9 pin 3
PIN5 >> DB9 pin 1
PIN6 >> DB9 2
PIN7 >> DB9 9